When you are working on a metal bed frame, you will assume it’s going to withstand regular stress and will work out as you want it to.
Yes, in most cases, the metal bed frame is going to last a long time and maintain its shape the way it is designed to.
However, you can have a situation where the metal bed frame begins to sag. This is when you need to learn how to fix a sagging metal bed frame.
To fix a sagging metal bed frame, it’s best to start by inspecting for loose bolts/nuts. Next, tighten these bolts and then add plywood underneath as support. You can also add a block underneath depending on what’s available. To complete the job, test the middle of the bed by putting weight on it.
A sagging metal bed frame can be fixed as long as you are taking the time to find the root cause.
This guide is going to highlight how to fix a sagging metal bed frame along with what to use to make sure it stays in the right position for a long time to come.
Table of Contents
Best Headboard (EDITOR’S CHOICE)
No products found.
Steps On How To Fix A Sagging Metal Bed Frame
1. Look For Loose Nuts Or Bolts
If a metal bed frame sags, it’s important to look for the most obvious issue.
This is going to come in the form of one of the nuts or bolts loosening. If you are regularly resting on a metal bed frame, it is going to start to weaken.
This happens over time and it is going to be hard to notice until the bed frame sags from one side.
In general, you will want to go to that side and look at the connecting points. This is going to highlight whether or not the issue has to do with a loose nut or bolt.
2. Tighten The Nuts And Bolts
You will now want to go to each nut or bolt in that area and tighten it.
The reason for doing this is to make sure a loose part is not the reason for the sagging metal bed frame. Only then will you be able to move forward to another part of the bed to see what can be done to fix it.
It is common for this to happen, so it should be a priority for you.
When you are tightening the loose bolts, you will want to make sure they are also holding the joint in place.
This means ensuring they are going through the hole and not just spinning in the same spot. This can happen when there is rusting in the metal bed frame or it is not as solid as it needs to be.
3. Place Plywood Underneath The Bed Frame
Let’s assume you have checked the loose bolts and they are good to go.
At this point, you might still have a sagging metal bed frame on your hands.
If that is the case, it is best to look to place something as a new base underneath the metal bed frame. This will have to come in the form of a piece of plywood.
The plywood is going to go near the sagging side and is going to prop it up.
4. Test The Bed Frame
You will want to put the plywood or block underneath the sagging area and then test it.
To test the metal bed frame, you will need to put weight on it. It is best to not jump on the bed frame as it might already be weak.
You will want to gradually add weight on top and see how the bed frame responds. If you notice it start to sag again, you might need to add another piece of plywood to the bottom of the bed frame.
The goal is to stabilize the bed frame and that is going to take a bit of time to do.
Final Thoughts
These are the main steps on how to fix a sagging metal bed frame.
To fix a sagging metal bed frame, it is best to start by tightening all of the loose bolts and/or nuts in the sagging area. Next, place a piece of plywood underneath and then re-test the bed frame to see if it still sags.
You will need to be patient when it comes to this part of the process.
It is common for your first fix to not work out as planned. This means you are going to have to keep solidifying the base as best as you can.
This can be done by being patient and making sure you are only focusing on the sagging part of the metal bed frame.
Here’s More On Bedrooms: