When a functional washing machine is working, you are going to see the wash cycle go through its phases and then the water drains.
However, this does not occur when the washing machine is malfunctioning.
You will notice a situation where the washing machine stopped full of water.
If the washing machine stopped full of water, it’s likely a water supply problem. Start by turning off the water, go to the water control panel, inspect for clogging, and pour vinegar into the machine to get rid of the clogging.
This is the only way to make sure you are not dealing with a situation where the washing machine starts overflowing.
This does happen if you are not careful and proactive.
Before things spiral out of control, your best option is to make sure you are getting the water out of the washing machine as soon as possible.
This guide will teach you more about what to do when fixing a washing machine that stopped full of water.
Table of Contents
Best Washing Sheets (EDITOR’S CHOICE)
No products found.
How To Fix Washing Machine That Stopped Full Of Water
1. Turn Off The Water
Before you begin diagnosing the problem with a washing machine that stopped full of water, it’s important to turn off the water.
You are going to go to the water valve and turn off the water going into the machine.
The reason for doing this is to ensure the water does not continue pouring into the washer as that will cause it to overflow.
This is one of the most important steps to keep the washer safe and also ensure you don’t flood the room it is in.
When you are testing the water supply, it is best to see if water is still going in. You will hear the noise stop when it is off.
This is what you will want to aim for to ensure the water is still not running in the back as you begin to look at the water control panel.

2. Open Water Control Panel
Now, it is time to start focusing on the water control panel.
There is going to be a plastic tube, which runs through the water control panel. This tube is hooked to the main water control valve.
In general, it is supposed to work properly and is going to allow the water level to be measured immediately.
Unfortunately, it is possible the water control valve is not going to be in the best shape as time goes on.
This is when you have to figure out where the clogged portion is.
3. Use Vinegar To Clear The Clogged Portion
Once you notice there is a clogged spot in the water control valve, it is time to start to work on unclogging it.
What are you going to use for this process?
You are going to use vinegar.
You will want to pour vinegar into the valve as that will allow it to clear out. It should work instantly and that is all you will need to get the draining to work again.
When the water control valve begins to pick up on the level inside the machine, it will know it’s time to drain the washer.

4. Re-Test The Washer
You will need to re-test the washing machine.
The goal is to see whether or not the water is going to drain out of the washing machine as soon as it is turned on.
The water control valve has to be in the right shape for this to happen.
When you are satisfied with the unclogging, you will need to begin connecting the washer again. Once it is powered on, you will notice it is going to immediately drain the water out.
This is a good sign and it means the washer is going to start working as you want it to again.
If it is still not draining, the water control valve might be damaged to the point of no return. This means it will need to be replaced.
Final Thoughts
These are the facts to think about if the washing machine has stopped full of water.
If the washing machine has stopped full of water, it’s best to turn off the water going to the washer. Next, open the water control panel, inspect the plastic tubing for a clog, and use vinegar to release the clogged portion. If this does not work, replace the tubing.
This is the only way you are going to make sure the washing machine drains as it needs to.
Otherwise, it is not going to pick up on the water level in the washer.
Here’s More On Homes: