Installing a shower pull switch is a common DIY project.
A lot of property owners aim to set this up but sometimes get the wiring crossed up. This might not seem like a major issue but it will become frustrating after a while.
The main issue has to do with when you notice the shower pull switch light stays on all the time.
If the shower pull light stays on, the permanent live conductor has likely been connected to the load side. To fix this, switch how the shower pull light is wired and make sure it’s connected to the right side. If not, the light will continue to stay on.
This is a common mistake and one that can easily be corrected with a bit of focus.
Don’t waste electricity by keeping the shower pull switch light on all the time. Look towards taking a screwdriver and reconnecting the permanent live conductor to the right side.
Here is a peek at what to do when it comes to handling a shower pull switch light that stays on.
Table of Contents
Best Showerhead For You (EDITOR’S CHOICE)
No products found.
Steps On How To Fix A Shower Pull Switch Light That Stays On
1. Check the Wiring
The main concern has to do with the wiring.
When installing the shower pull light switch, people will often wrongly connect the permanent live conductor. Remember, the load goes across, so having it on the “load” side is going to keep the electricity moving through to the light.
This means the switch is not going to work even when you pull down.
As a result, it’s important to fix the shower pull switch light by switching how the permanent live conductor is connected.
2. Switch the Connection Points
You will want to look at the connection points.
The wire will have multiple connection points when you set up the shower pull light switch. When set up the right way, pulling down on the cord is going to turn off the power.
However, when you leave it on the “load” side, this is when the shower pull light switch stays on all the time.
The solution itself is easy.
Look at where the connection points are right now and switch them around. This should only take a few seconds to do, especially if you were the one who installed it.
3. Use Screwdriver To Tighten The Wiring
If the shower pull switch light is always on, you are going to want to tighten the wiring too.
The reason for doing this is to make sure the wiring stays intact for a long time to come. Sometimes, when you are fiddling around with the wiring, it will become loose and burn out.
To avoid a situation such as this, tighten the shower pull switch light wiring with the help of a simple screwdriver.
The screwdriver will help make sure the wiring stays where it has been connected. This is essential for the longevity of the component.

4. Test the Shower Pull Switch Light
You will now want to focus on testing the shower pull switch light.
The goal here is to see whether or not the load is going through as expected. If you pull down on the cord now, it is going to turn off.
This means the shower pull switch light is working the way it is supposed to.
For the most part, it is highly recommended to continually test the shower pull switch light as often as possible. This ensures any issues that arise are taken care of before you waste electricity.
Can I Leave My Shower Pull Switch On All the Time?
You can leave a shower pull switch on all the time. However, this is not recommended as it is a waste of energy and it can also become a safety concern when new connection points are attached to the circuit.
It’s best to have all of the wires in the right place to ensure the current goes through as required.
Final Thoughts
These are the steps to implement when figuring out how to fix a shower pull light that stays on all the time.
To fix a shower pull light that stays on, you will have to look at where the permanent live conductor is connected. If it is connected to the “load” part of the circuit, this will mean the electricity is going to go right through whether the cord is pulled or not. The best solution is to switch the connection points and tighten them using a screwdriver.
It is a simple fix that is going to work within seconds.
Read More On Bathrooms: